OCTOEASY anti-lift device 2-link
suitable for roller shutter shaft SW40
The advantages of the anti-lift device at a glance:
- burglar-resistant, as it prevents a closed, motorised roller shutter from being pushed up
- for roller shutter motors with electronic or mechanical limit switching
- for octagonal shafts 40 mm
- the maximum pulling force is 7 kg armoured weight per anti-lift device
The links of the anti-lift device are made of glass fibre-reinforced polyamide. They are connected to each other using a hinge principle and cannot disengage when the roller shutter is rolled up and down.
The anti-lift device can be attached using a stainless steel quick-connect clip system by moving the connector sideways on SW40 octagonal shafts with 5x8 mm square holes.
Suitable for hole spacing of square holes of 60 and 75 mm.
There are also 2 round holes Ø 4.5 on the first link to screw or rivet the spring to the shaft for fastening on an 8-sided shaft.
Important: Please ensure that the screws do not damage the motor.
The connection to the armour is made via a mounting profile that can be used for 8 mm roller shutter rods.
Number of anti-lift devices per roller shutter:
| Roller shutter width ALU |
Minimum number |
| up to 140 cm |
2 OctoEasy |
| 141 - 235 cm |
3 OctoEasy |
| 236 - 333 cm |
4 OctoEasy |
| Roller shutter width PVC |
Minimum number |
| up to 120 cm |
2 OctoEasy |
| 121 - 170 cm |
3 OctoEasy |
| 171 - 220 cm |
4 OctoEasy |
Mounting the anti-lift device:
- slide the mounting profiles of the OctoEasy onto the first bar of the roller shutter curtain
- let the roller shutter curtain into the guide rails
- fasten the OctoEasy anti-lift device to the shaft using the quick-connect clip system or screws
Data sheet 
Instructions for use
WEEE-Reg. No.: DE 77028333
| Item information |
Value |
| Shipping weight: |
0,09 kg
|
| Item weight: |
0,09 kg
|
Manufacturer/EU Responsible person
3T-Components GmbH & Co. KG
Grete-Schickedanz-Straße 5
55545 Bad Kreuznach
Germany
Phone: 0671 887 673 0
E-Mail: info@3t-components.de
